Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Window Company in Richmond Heights, FL
Juniper Windows & Doors is the window and door specialist for Richmond Heights, FL, handling everything from full-home window replacement to single door swaps. Homes here sit close to the coast and take real punishment from salt air, humidity, and the occasional tropical system, so the work tends to focus on impact-rated glass, corrosion-resistant hardware, and properly sealed frames. Whether you’re dealing with fogged panes, a sticking slider, or a front door that no longer closes square, call (682) 281-2168 and we’ll give you a written price before anything starts.
Why Richmond Heights Homes Are Different
Richmond Heights was built out mostly in the mid-20th century, which means a lot of the original window and door openings were framed for single-pane glass and thin aluminum extrusions. Those products made sense when they were installed; today they leak conditioned air, rattle in wind, and offer almost nothing against wind-borne debris. Many homes have since been partially updated, so we regularly see a mix of old and new in the same house – an impact-rated front door next to twenty-year-old side windows. That patchwork creates uneven sightlines and thermal gaps, and it’s one of the first things we address when we walk a job.
The other big factor is moisture. Richmond Heights sits on flat, low-lying ground with a high water table. Humidity is a daily fact, not a seasonal visitor. We look carefully at sill pans, weep holes, and the sealant lines where stucco meets frame. A window that works fine in a drier climate will rot a wood buck or grow mold on the interior drywall here within a few seasons if it’s flashed incorrectly. Our crews use stainless and galvanized fasteners on exterior work for the same reason – standard plated screws corrode fast in this air.
Permits matter here too. Richmond Heights falls under Miami-Dade County code, which has some of the strictest wind-load and impact requirements in Florida. Any window or door replacement that changes the opening size or alters structural framing needs a permit, and the product selection has to match the wind zone mapped for the specific address. We handle that paperwork and the inspections as part of the job. If a contractor tells you permits are optional for replacement work in Richmond Heights, walk away.
Our Main Richmond Heights Services
Most Richmond Heights homeowners reach out for one of three reasons: windows that have failed or fogged, new construction or additions that need properly sealed openings, or doors that have warped, rotted, or lost their seal. Each service has its own detailed page below.
Window Replacement in Richmond Heights
Replacement work in Richmond Heights usually means pulling old aluminum or wood frames and setting new impact-rated units into the existing openings. The job involves assessing the current flashing, repairing any rotted buck, and sizing the new glass to match the home’s wind zone rating. Salt air and humidity mean we specify thermally broken frames and stainless hardware as standard here. If you’re tired of cranking a window that won’t seal or cleaning condensation between panes, see the full scope on Window Replacement in Richmond Heights.

Window Installation in Richmond Heights
New installation is different from replacement. This covers new openings, additions, and remodels where the rough framing is being built fresh. In Richmond Heights, that means working with the GC or builder to get the opening sized correctly before the stucco goes on, then installing and flashing the unit so it survives a driving rain. We stock and install eight product lines so the architect’s spec or the homeowner’s energy target doesn’t get compromised. Details on process and rough-opening prep are on the Window Installation in Richmond Heights page.

Door Replacement in Richmond Heights
Front doors in Richmond Heights take sun on one side and air conditioning on the other, which warps wood and breaks down foam cores within a few years. We replace entry doors, French doors, sliders, and sideyard doors, and we pay close attention to threshold height, sweep seals, and the jamb-to-stucco transition. A door that doesn’t latch or drags against the floor is more than annoying – it’s an air leak and, over time, a rot problem. See what door replacement covers in this area on Door Replacement in Richmond Heights.

What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Richmond Heights
We work with CGI, CWS, and ES Windows in Richmond Heights, plus ECO Window Systems when the project calls for a mid-range thermal break without sacrificing the wind rating. Because these lines are stocked locally, we can usually turn around standard sizes faster than special-order-only shops. See all the lines we carry on our brands page.
Pricing for Window Company in Richmond Heights, FL
| Service | Typical range in Richmond Heights |
|---|---|
| Single window replacement (impact-rated) | $900 – $2,400 |
| Full-home window replacement (10 – 15 windows) | $12,000 – $28,000 |
| Standard window installation (new opening, no sill repair) | $400 – $900 per opening |
| Stucco repair around new window (per opening) | $150 – $400 |
| Entry door replacement (fiberglass, pre-hung) | $1,800 – $4,500 |
| Sliding glass door replacement (impact-rated) | $2,500 – $6,000 |
| French door replacement (pair, impact-rated) | $4,000 – $9,500 |
| Door installation (new opening, no framing changes) | $600 – $1,400 |
| Rotted sill or buck repair (per opening) | $250 – $800 |
| Full-home retrofit with trim and flashing | $15,000 – $35,000 |
What pushes cost up in Richmond Heights is usually the wind rating and the condition of the existing rough opening. A 1960s home with rotted wood framing and no current flashing will cost more than a newer home where the openings are clean. Whatever the number is, you get it in writing before we order materials – no surprise invoice, no door-knock adjustment.
Neighborhoods We Serve in Richmond Heights
We work across the mix of housing in Richmond Heights, from original mid-century ranches to more recent infill builds. Crews stage from the Miami metro office and typically reach most Richmond Heights jobs within the same scheduling window.
- Richmond Heights core, around the County Park and school zones
- West Perrine border off Eureka Drive
- Palmetto Estates boundary along US-1
- South Miami Heights edge near Galloway Road
- Cutler Bay side of the Southland Mall corridor
Service Area – Cities Near Richmond Heights
Richmond Heights sits at the center of South Miami-Dade, and we run jobs throughout the surrounding metros. Homeowners in Miami, FL and Hialeah, FL call us for replacement work, while Fort Lauderdale, FL and Pembroke Pines, FL are within our regular scheduling range. If your zip code isn’t listed, call and ask – chances are we cover it.
Serving Richmond Heights, FL - Our Local Coverage Area
We’re based in the Richmond Heights area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Window Company in Richmond Heights
Most Richmond Heights jobs are scheduled within a few business days, not weeks. We coordinate from the Miami metro office, and because our product lines are stocked locally, we avoid multi-week freight delays on standard sizes. Call (682) 281-2168 with your address and we’ll give you a real window, not a four-hour “sometime.”
Yes, in most cases. Miami-Dade code requires permits for window and door replacement, especially for impact-rated openings, and the product must match the wind zone for the specific address. We pull permits, schedule inspections, and close the job with a passed final – all part of the written quote.
Both. We replace windows and doors in the original mid-century homes, the 1980s and 90s remodels, and brand-new infill builds. Older homes often need rough-opening repair before install, and we scope that in writing upfront so it’s never a hidden cost discovered midway through the job.
If you’re ready for a straight answer and a price that won’t move, call (682) 281-2168. We’ll schedule a free estimate, walk the openings with you, and put the number in writing before any work begins.
What happens when you call
- 1A real person answersNo phone trees - talk to a local windows & doors pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Richmond Heights Customers Say
"Front door looks great and shuts well. The threshold is sealed well and the lock lines up with the strike."
- Rory F."Quote came in the app with options for glass. Easy to compare."
- Vera L."Door replacement. Installer texted when on his way and finished by lunch. Tight and clean."
- Neil B.










Before
After
Before
After
Before
After